Midea MHC-96HWD1N1(A) Service Manual page 35

MCAC-UTSM-201503

The wiring must be performed by professional technicians according to the circuit diagram
labels.

Distribute the wires according to the relevant electric technical standards promulgated by the
State, and set the Residual Current-operated Circuit Breaker (RCCB) properly.

The power wire and the signal wire shall be laid out neatly and properly, without mutual
interference or contacting the connection pipe or valve.

No power cable is attached to this equipment. The user can select the power cable by reference
to the stipulated power supply specifications. No joint of wires is allowed.

Upon completion of wire connection, double check it and then connect the power supply.

An all-pole disconnection device which has at least 3mm separation distance in all pole and a
residual current device (RCD) with the rating of above 10mA shall be incorporated in the fixed
wiring according to the national rule.

The appliance shall be installed in accordance with national wiring regulations.
5.2 Specifications of power supply
Model
Power
Switch capacity of the main power
supply / Fuse(A)
Indoor unit power cable
Outdoor unit power cable
Indoor Unit /Outdoor Unit Signal Wire
(mm2) (Weak electric signal)
5.3 Schematic diagram
R410A Full DC Inverter Split Duct Type Technical Manual
MHC-96HWD1N1(A)
220-240V~50Hz
16/16
2
3×2.5mm (Includes grounded wire)
\
3-core shielded wire 3×0.75
MOUA-96HD1N1-R
380-415V 3N~50Hz
40/40
/
2
5×6.0mm (Includes grounded wire)
34