Advertisement
8. Run the remaining type-c connection
along the support frame and the
trim panel leading to the 12v socket
exposed in step 4 of the disassembly.
Make all necessary vehicle
connections as shown in the diagram
above under
Testing Qi Module.
9.
Route the type-c connector through the
TIQ01 direct-fit bezel. Repeat this step for
both Qi module slots on the bezel.
Notes:
• Hide any excess wiring under the panels before
reassembling.
• Use the provided two-sided adhesives to secure
the panel/module from moving.
10. Connect the type-c connector to the
MQUSM modules.
Notes:
• Hide any excess wiring under the panels
before reassembling.
• Use the provided two-sided adhesives to
secure the panel/module from moving.
11. Reassemble everything in reverse
order to complete the installation,
and place your Qi enabled device on
to the newly installed platform.
PREPARATION
VEHICLE ASSEMB
7
Page 6 Cont'd
Advertisement
