Advertisement
Accessing 12V Power
4. Remove the (4) screws securing
the cup-holder panel, unplug all
connections then remove the panel
from location.
Note: The 12 volt power connection
can be located here. This will be the
source of power for the Qi module.
5. Remove the following in the order
listed below F-H:
F. Remove the bottom trim panel
from the phone dock. To remove,
slide towards the driver-side then
pull the panel away from location.
Remove rubber mat
G. Slip and remove the existing
H. phone charging cables away
from the center console's phone
placement panel.
6.
Lift the phone dock then remove (4)
torx screws located at the back of
the panel, then carefully pull out the
panel away from location (reference
illustration 6 at right). 1
'
■
1. Removing the phone placement panel may require a bit of force when pulling the panel away.
VEHICLE DISASSEMBLY
If you have any questions or need technical assistance with the installation, or
the most current application please call or visit us on the web at:
(800) 363-4490 x1 I www.scosche.com/contact
5
Advertisement
