Copy Function - Delta DPA Series Instruction Sheet

[Figure 4: Full range analog Output]
 Key Locking Function
 Lock On: Press and
set value (SV).
 Lock Off: Press and
set value (SV).
 Lock Display: Press any key in the key locking mode, and you will see the display of pressure value (PV) and
key, and the PV and SV will return to original values.
 Switching Colors
In DPA, different output statuses can have different display colors. The output statuses for DPA are "OUT1", "OUT2", "OUT1 and OUT2",
"OUT1 or OUT2". See below explanations for how to set:
1. Setting up output status: In the "Measuring Mode", press
are now in the "Advanced Setup Mode". Press
chart). Use to select the referencing item you'd like.
2. Switching colors: In the "Measuring Mode", press
and find the parameter for setting up colors (see Quick Setup Mode chart). Use

Note: "OUT1 and OUT2" will be ON only when both OUT1 and OUT2 are ON; otherwise, it will be OFF. "OUT1 or OUT2" will be OFF only
when both OUT1 and OUT2 are OFF; otherwise, it will be ON.
 Copy Function
DPA is able to copy the parameters in the master device to another slave device.
1. Hardware: Connect Pin 2 on master to Pin 3 on slave; Pin 3 on master to Pin 2 on slave; Pin 5 on master and slave to GND on power
supply; Pin 1 on master and slave to +24V on power supply.
2. Software:
a) Slave device: In the "Measuring Mode", press
the "Advanced Setup Mode". Press
Mode chart). Use
b) Master device: In the "Measuring Mode", press
in the "Advanced Setup Mode". Press
Mode chart). Use
to the "Measuring Mode". Now, you will see
have been connected. On
successfully between the two devices. Once the copy of parameter succeeds, you will see
together for 2 seconds until
together for 2 seconds until
for 5 times and find the switching color referencing items (see Advanced Setup Mode
for more than 2 seconds to enter the "Quick Setup Mode". Press
for more than 4 seconds and release the key after you see
for 7 times and find the parameter for setting up the copy function (see Advanced Setup
to select (
for more than 2 seconds and release the key after you see
for 7 times and find the parameter for setting up the copy function (see Advanced Setup
to select (
on the screen and
, you will see numbering counting up, referring to the number of parameters transmitted
S-L
[Figure 5: Change analog slop Output]
is displayed. You will then see the display of pressure value (PV) and
is displayed. You will then see the display of pressure value (PV) and
for more than 4 seconds and release the key after you see
refers to Copy-Slave).
refers to Copy-Master). Next, press
on the slave device, indicating that the two devices
- 7 -
S-H
to select the color you'd like.
for more than 2 seconds and return
on the master device and
(SV). Release the
. You
for 4 times
. You are now in
. You are now