Initial Setting; Output Mode Setting - Delta DPA Series Instruction Sheet

Quick Setup Mode
Set up N.O./N.C. of OUT1 and
OUT2
Set up output response time
Set up PV display color
Set up unit
 Return to "set up OUT1 mode"
Press
 Initial Setting
1. Units: DPA provides many units for users, including kPa, kgf/cm
find to set the unit to the desired one.
2. Output status: You can set up 2 output status in DPA, N.O. (normally open) and N.C. (normally closed). In the easy mode, you can press
and fine
3. Response time: Referring to the time required for the pressure to reach output status. For example, "50" refers to once the pressure has
reached the output status, it has to last for 50ms before the output starts to operate. In the easy mode, press
Use to set up the response time.
 Output Mode Setting
There are 3 output modes in DPA: Easy, Hysteresis and Window
1. Easy Mode: Set up pressure P. When the pressure measured is bigger than (P + dP), the output will be ON. When the pressure measured
is smaller than P, the output will be OFF. (See Figure 1: Output in Easy Mode)
 In the "Measuring Mode", press
 In the "Advanced Setup Mode", press

Press

Press
output items
Press 
Press
to set up the output status for OUT1 and OUT2.
and find
and find
Advanced Setup Mode
Set up hysteresis
Press
Set up power saving mode
Press
Set up switching color referencing
Press
Set up code
Press
Set up copy function
Press
Set up analog output switch
Press
Return to default settings
 Return to "set up auxiliary
2
, bar, psi, mmHg and inchHg. In the easy mode, you can press
(OUT1) and
. Use to set up "dP" value.
[Figure 1: Output in Easy Mode]
- 5 -
Measuring Mode
SV of OUT1
(Set OUT1 to easy mode)

Set up upper limit of OUT2
(Set OUT2 to hysteresis mode / window
mode)

Set up lower limit of OUT2
(Set OUT2 to hysteresis mode / window
mode)

SV of OUT2
(Set OUT2 to easy mode)

Press  Returning to output setting


display"
(OUT2). Use to set up P value.
Press 
Press 
Press 
and
and find .