1. Product Introduction Clenergy PV-ezRack SolarMatrix is a mounting system with tilt angle 5 ° , 10 ° , 15 ° and 20 ° and suitable for non-penetrating roof in medium wind load region where wind speed is within 40m/s. The system could be installed easily with simple tools.
3. System Overview Overview of PV-ezRack SolarMatrix Stainless Steel Fastener Installation Precautions Improper operation may lead to deadlock of Bolts and Nut. Follow the steps below to reduce this risk 1.Reduce the friction coefficient: (1)Ensure that the thread surface is clean and free of dirt or contaminant;...
Page 5
Please refer to safe torques defined in this guide as shown below; In case power tools are required, Clenergy recommends only low-speed tools. High-speed and impact drivers increase the risk of bolt galling (deadlock). If deadlock occurs, you need to cut fasteners please make sure that there is no load on the fastener before you cut it.
Page 6
Installation Dimensions All drawings and dimensions in this installation guide are for a generic reference. The Clenergy PV-ezRack SolarMatrix is optimized to suit specific conditions for each project and documented in a construction drawing. As a result, major components of the Clenergy PV-ezRack SolarMatrix may be provided in section sizes and lengths that No.
In case you need to do any on-site modifications or alteration of the system in a way that would be different from the construction drawing please provide marked up drawings/sketches for Clenergy’s review prior to modification for comment and approval.
Clenergy’s written installation instructions, or if the Product has been modified, repaired, or reworked in a manner not previously authorized by Clenergy IN WRITING, or if the Product is installed in an environment for which it was not designed. Clenergy shall not be liable for consequential, contingent or incidental damages arising out of the use of the Product by Purchaser under any circumstances.
Need help?
Do you have a question about the PV-ezRack SolarMatrix and is the answer not in the manual?
Questions and answers