Advertisement
Step 2: Mount Arms to TV
1. Determine the diameter of the screw (parts D through H) your
TV requires by carefully trying to hand-thread one into the
threaded insert on the rear of the TV. If there is any resistance,
stop immediately.
2. Thread the screw through the washer (L or M), arm, spacer (I,
J, or K), and into the TV.
NOTE: Spacers are commonly needed on TVs with curved backs or
recessed screw inserts.
3. Ensure the arms are installed flat side to TV and are square to
each other after all screws have been installed (Figure 3).
Step 3: Hang TV on to the Wall Plate
Carefully lift the TV to hook the arms over the top lip of the wall
plate. The bottom of the arms will then rest on the top edge of the
locking mechanism. The locking mechanism can be released by
pulling the pull strings down and allowing the TV to slide into place.
Once you release the pull strings the TV will be locked. Do not
release the TV until it is completely connected to the wall plate.
Adjustments:
Adjust Horizontal Level and Tilt
Forward Tilt Adjustment
4. Turn Tilt Adjustment Lever (ratchet) clockwise to tighten grip;
counter-clockwise to loosen grip.
5. Pull Tilt Adjustment Lever (ratchet) away from arm and then
turn Clockwise/counter-clockwise to desired location. Let the
Tilt Adjustment Lever (ratchet) sit in place.
6. Repeat as needed to loosen/tighten the tilt.
Horizontal Adjustment
If display is not horizontally level when mounted, Tilt Adjustment
Screws are included at the top of each arm for micro-adjustments
(Figure 6). Use provided Allen Key to raise or lower the screw,
which will in turn raise or lower the mount.
NOTE: Caution should be taken to avoid any slips or drops to avoid
damage and/or injuries.
Lifetime Limited Warranty
Strong™ Mounts have a Lifetime Limited Warranty. This warranty
Lifetime
includes parts and labor repairs on all components found to be
defective in material or workmanship under normal conditions of
use. This warranty shall not apply to products which have been
abused, modified or disassembled. Products to be repaired under
this warranty must be returned to SnapAV or a designated service
center with prior notification and an assigned return authorization
(RA) number.
For Technical Support call 1.866.838.5052
Figure 3
Note: Tilt arms shown installed on display.
Figure 4
12°
Figure 5
Figure 6
© 2019 STRONG™
190703-1300
Fixed
Tilt
5°
Tilt Adjustment Lever
(Ratchet)
±5° Horizontal
Adjustment
Tilt Adjustment
Screw
Locking
Tab
Tilt Arms
Advertisement
