Advertisement
IMAGE
Spacer
Spacer
Spacer
M6 Washer
M8 Washer
Allen Key
INSTALLATION:
Step 1: Mount the Wall Bracket Assembly
For Mounting on a Wood Stud Wall
1. Pre-drill holes into two wood studs using a 3/32" drill bit.
Be sure to drill into the center of the studs at least 2-1/2"
deep. The use of a stud finder is highly recommended.
2. Insert four Lag Bolts (A) and Lag Washer (B) into holes
through the Wall Plate and tighten down (Figure 1).
WARNING: Stud sizes must be a minimum of 2"x4" and
covered with no more than 3/8" thick dry wall.
For Mounting on a Concrete Wall
3. Pre-drill holes into concrete using 5/16" drill bits to a
depth of 2-1/2". Insert concrete wall anchors (C) and tap in
with hammer, if necessary (Figure 2).
WARNING: When installing wall arm assembly on cinder
block, verify first that you have a minimum of 1-3/8" of concrete
thickness to be used for the concrete anchors. Do not drill into
mortar joints! Be sure to mount in a solid part of the block,
generally 1"minimum from the side of the block. Cinder block
must meet ASTM C-90 specifications. It is suggested that a
standard electric drill on slow setting is used to drill the hole
instead of a hammer drill to avoid breaking out the back of the
hole when entering a void or cavity.
CONCRETE must be 2500psi density minimum. Lighter
density concrete may not hold concrete anchor. Make
sure that the supporting surface will safely support the
combined load of the equipment and all attached hardware
and components.
4. Insert four Lag Bolts (A) into the wall anchors (C) through
the Wall Plate. Tighten all bolts.
WARNING: Tighten bolts so that wall plate is firmly attached,
but do not overtighten. Overtightening can damage the
bolts, greatly reducing their holding strength.
www.snapav.com Support: 866.838.5052
DESCRIPTION
ITEM
(I) 8.5 × 5 mm
(J) 8.5 × 19 mm
(K) 8.5 × 22 mm
(L) 6.4 × 18 × 2 mm
(M) 8.4 × 20 × 2 mm
(N) M4 × 358 x 50 mm
Figure 1
Bolts
Figure 2
Drill holes and
insert anchors.
Place wall arm
assembly plate
over anchor and
secure with
lag bolt.
Tighten all
lag bolts.
Installation Manual
QUANTITY
Center of Studs
Concrete
Wall
Wall Arm
Lag Bolt
4
4
4
8
8
1
Bolts
3
Advertisement
