Storage; Repairs And Changing The Carbon Brushes - Westfalia 45 85 13 Instruction Manual

Thin branches can be cut off with one single cut. To prevent the branch
from slivering and buckling the branch should be cut off in several pieces.
When cutting off lager branches, you should first cut into the branch form
below. First cut into the branch from below outside the place where you
intend to cut off the branch. The cut should go from one third to halfway
through the branch. This prevents the branch from buckling when you cut
into the branch from the top outside the first cut. Last, cut off the stump
with one clean cut. You might want to seal the cut with a suitable
compound.
First Cut

Storage

If you do not intent to use the Westfalia Electric Pole Saw for some time,
e.g. over the winter, the bio-degradable chainsaw oil must be drained from
the oil tank and the oil ducts, because it will gum.
Pour remaining oil out of the oil tank and store it in a dark, cool place. Pour
a spoonful of mineral oil into the oil tank. Spray penetrating lubricant on
the chain and let the saw run for a few moments to spread the mineral oil
through the oil pump and the oil ducts. When using the pole saw again
liberally apply chainsaw oil. Hang the pole saw upright, with the saw end
on top, by its build-in hook.

Repairs and Changing the Carbon Brushes

Repairs beyond those described above, should only be undertaken by
trained personal. Should a malfunction occur do not use the unit any
further and do not attempt to repair it yourself.
Contact the Westfalia Customer Support or have the unit repaired by a
professional. The included carbon brushes are intended as spare parts for
installation by a professional.
Operation
Second Cut
14
Third Cut