Conformity Declarations - FLARM POWERFLARM FUSION Installation Manual

FLARM Technology Ltd
Hinterbergstrasse 15
CH-6330 Cham
Fusion is not supported by the PC software FLARM Tool for Classic FLARM.

Firmware updates, IGC file downloads, and obstacle data uploads cannot be
done via the data ports. Instead, they are done via FLARM Hub or with a USB
flash drive. The USB extension cable should be installed in the instrument
panel. USB data transfer is also faster than over the data ports. See the User
and Maintenance Manual for details.
4.5

Conformity Declarations

FLARM Technology Ltd, Hinterbergstrasse 15, CH-6330 Cham, Switzerland,
declares that the product PowerFLARM Fusion in Hardware Version FLAFUS*** and
typical configuration, meets the requirements of the CE mark.
The communications conformity meets the requirements of EN 300 220 (power
class 9), EMC Conformity EN 301 489 (class 3 SRD-Device, equipment type I). The
device is in accord with the requirements of the European R&TTE Directive.
FCC ID:
2AXJM-FLAFUS10W
This device complies with Part 15 of the FCC. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
Within the USA, the device may only be used in transportation vehicles such as
aircraft or motor vehicles.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du
Canada.
POWERFLARM FUSION
INSTALLATION MANUAL
Date: 2020-11-10
Version: 1.0
Page: 28 of 38
Document Number:
FTD-077