Minor Change And Standard Change; Housing - FLARM POWERFLARM FUSION Installation Manual

FLARM Technology Ltd
Hinterbergstrasse 15
CH-6330 Cham
2.1.1

Minor Change and Standard Change

For certified aircraft, an MCA (Minor Change Approval) or Standard Change
installation with appurtenant documents is required. The MCA covering many
aircraft types, as well as required Standard Change documentation, can be
acquired under the following link:
https://flarm.com/product-category/approvals/
The documents are also required for a Standard Change installation. This includes
the AFM Supplement, Installation instructions, as well as Instructions for continued
airworthiness. These documents can also be used for an individual Minor Change
for other aircraft types.
Note: A Standard Change installation is normally more limiting than an MCA (e.g.
limited to day VFR).
2.2

Housing

Mount PowerFLARM Fusion to a suitable mounting location. The orientation of the
device is discretionary. Do not mount the device on the "hot" side (engine side) of
the firewall. Common installation locations are behind the instrument panel or in
the E&E compartment in larger aircraft. To ensure that the Wi-Fi and Bluetooth
connection works for the pilots (if it is intended to be used), install Fusion in a
location that does not hinder the propagation of the Wi-Fi and Bluetooth signal to
the pilot compartment. The Wi-Fi and Bluetooth antenna is located behind the
sticker indicated below:
The metallic housing is not waterproof, and ingress of solid particles and liquids
must be avoided. Should the device get moist, it must be completely dried prior
to further use. If the device becomes wet, it may be permanently damaged and
POWERFLARM FUSION
INSTALLATION MANUAL
Wi-Fi and Bluetooth antenna location
Date: 2020-11-10
Version: 1.0
Page: 12 of 38
Document Number:
FTD-077