Charge Amps HALO Wallbox Installation Manual

Hide thumbs Also See for HALO Wallbox:

Download this manual

HALO Wallbox™

INSTALLATION GUIDE

This guide is for TN and IT net.

The installation must be performed by an authorised electrician.

The installation must be protected by a type A RCD (DC protection is integrated in the HALO).

1. Mount the wifi antenna under-

neath the HALO as the picture.

2. Drill holes for the HALO using

the drill template included and a

spirit tool, plug the holes. Make

sure you are mounting the HALO

on a flat surface.

3. Mount the HALO and ensure

mounting is sealed closely to the

wall to prevent water leaking into

the housing.

Page 1 HALO Wallbox™ INSTALLATION GUIDE This guide is for TN and IT net. The installation must be performed by an authorised electrician. The installation must be protected by a type A RCD (DC protection is integrated in the HALO). 1. Mount the wifi antenna under- neath the HALO as the picture.
Page 2 3. If you have removed the ca- bles previous to mounting, en- sure you click the antenna back into the white holders to pre- vent it from getting damaged when mounting the lid. See picture. 4. If choosing to let all the ca- bles stay connected to the lid as you mount the HALO to the wall, ensure you hold the lid...
Page 3 HALO Wallbox™ 1-Phase TN and IT Net Recommended for load balancing purposes (TN Net) (IT Net) 1. Power supply 2. Wifi- antenna 3. LED connection 4. EV connector 5. Schuko connection HALO Wallbox™ 3-Phase Only TN Net (TN Net)
Page 4 HALO Wallbox™ TECHNICAL INSTALLATION DATA CHARGING CURRENT 3.7kW: 1x16 A 11kW: 3x16A 7.4kW: 1x32A VOLTAGE 100-240 V FREQUENCY 50/60 Hz ENVOIRONMENT CONDITIONS Indoor and Outdoor <95% humidity MOUNTING METHOD Mounted on flat surfaces ELECTRIC SHOCK PROTECTION Class 1 equipment CHARGING MODE...