Table of Contents
Advertisement
Rear I/O Ports
X
USB Ports
„ USB 6 (USB 2.0)
„ USB 5 (USB 2.0)
„ USB 2 (USB 3.1 Gen 1)
„ USB 1 (USB 3.1 Gen 1)
USB allows data exchange between your computer and a wide range of simultaneously
accessible external Plug and Play peripherals. The system board is equipped with multiple USB
Type A ports at the rear side — two USB 2.0 ports, two USB 3.1 Gen1 ports, and two USB 3.1
Gen2 ports. For the internal USB ports and connectors, please refer to the next section.
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S3 (STR - Suspend To RAM) state.
User's Manual | CS350
„ USB 4 (USB 3.1 Gen 2)
„ USB 3 (USB 3.1 Gen 2)
Rear I/O Ports
X
Graphics Display
„ DP++
„ DVI-I (DVI-D Signal)
„ HDMI
DisplayPort ++
The DisplayPort (DP) is a digital display interface used to connect a display device such as a
computer monitor. It is used to transmit audio and video simultaneously. The interface, which
is developed by VESA, delivers higher performance features than any other digital interface.
DP++ is supported by the system board for converting to DVI and HDMI signals.
HDMI
The HDMI port which carries both digital audio and video signals is used to connect a LCD
monitor or digital TV that has the HDMI port.
DVI-I (DVI-D Signal) Port
The DVI-I port is used to connect a LCD monitor. This port supports DVI-D signal only. Connect
the display device's cable connector to the DVI-I port. After plugging the cable connector into
the port, gently tighten the cable screws to hold the connector in place.
Chapter 2
HARDWARE INSTALLATION
19
Advertisement
Table of Contents
