Table of Contents
Advertisement
X CPU
The system board is equipped with a surface mount LGA 1151 socket. This socket is
exclusively designed for installing a LGA 1151 packaged Intel CPU.
Protective cap
Important:
1. Before you proceed, make sure (1) the LGA 1151 socket
comes with a protective cap, (2) the cap is not damaged and (3)
the socket's contact pins are not bent. If the cap is missing or
the cap and/or contact pins are damaged, contact your dealer
immediately.
2. Make sure to keep the protective cap. RMA requests will be
accepted and processed only if the LGA 1151 socket comes with
the protective cap.
Note:
The system board used in the following illustrations may not
resemble the actual board. These illustrations and photos are for
reference only.
User's Manual | CS350
Installing the CPU
1. Make sure the PC and all other peripheral devices connected to it have been powered
down.
2. Disconnect all power cords and cables.
3. Locate the LGA 1151 CPU socket on the system board.
Important:
The CPU socket must not come in contact with anything
other than the CPU. Avoid unnecessary exposure. Remove the
protective cap only when you are about to install the CPU.
4. Unlock the socket by pressing
the load lever down, moving it
sideways until to escape the
retention tab. Lift the load lever
up when it's released.
Chapter 2
HARDWARE INSTALLATION
Load lever
Retention tab
12
Advertisement
Table of Contents
