125986546.qxp
2008-01-23
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Centre, please carry out the
checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes to indicate that the
machine is not working.
Once the problem has been eliminated, press the Start/Pause button to restart the programme. If
after all checks, the problem persists, contact your local Service Centre.
Malfunction
Dryer does not work.
Drying results
unsatisfactory.
Loading door does not
close.
16
10:33
Page 16
Possible cause
Mains plug is not plugged in or fuse
●
is not working correctly.
Loading door is open.
●
Have you pressed the START/
●
PAUSE button?
Wrong programme selected.
●
Lint filter clogged.
●
Heat exchanger clogged with lint.
●
Incorrect volume of laundry.
●
Ventilation slots in base area covered up.
●
Residue on inside surface of
●
drum or drum ribs.
Conductance of water at installation
●
site differs from
standard setting of machine.
Fine strainer not in place and/or large
●
mesh filter not locked in place.
Solution
Plug in at mains socket. Check fuse
●
in fuse box (domestic installation).
Close loading door.
●
Press the START/PAUSE button
●
again.
Select a different programme the next
●
time you dry.
Clean lint filter.
●
Clean heat exchanger.
●
Observe recommended loading
●
volumes.
Uncover ventilation slots in base area.
●
Clean inside surface of drum and
●
drum ribs
Re-programme standard setting for
●
degree of drying.
Install fine strainer and/or snap large
●
mesh filter into place.