125986546.qxp
2008-01-23
Malfunction
When pressing a button,
the corresponding
button flashes several
times.
Drying cycle ends
shortly after programme starts.
END
light illuminated.
Programme inactive,
Condenser
light illuminated.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle complete")
If you are unable to identify or solve the
problem, contact your local Service Centre.
Before telephoning, make a note of the model,
serial number and purchase date of your
machine: the Service Centre will require this
information.
10:33
Page 17
Possible cause
Washing protection.
●
After the start of the programme,
the option can no longer be set.
Not enough washing loaded
●
or washing loaded is too
dry for selected programme.
Condensate tank is full.
●
Lint filter clogged.
●
Heat exchanger clogged with lint.
●
DELICATE button pressed and
●
load volume too big.
Load volume too big.
●
Laundry insufficiently predrained.
●
If you call out an engineer to a fault listed below,
or to repair a fault caused by incorrect use or
installation, a charge will be made even if the
appliance is under guarantee.
Solution
Turn the programme knob to OFF. Set
●
the programme again
Select time programme or
●
higher drying level (e.g. EXTRA DRY
instead of CUPBOARD).
Empty condensate tank, then start
●
programme with START/PAUSE
button.
Clean lint filter
●
Clean heat exchanger.
●
DELICATE is only suitable for use
●
with loads of up to 3 kg!
Reduce load volume.
●
Laundry must be adequately
●
pre-drained.
Important:
17