Maintenance And Cleaning; External Cleaning; Cleaning The Door; Cleaning The Filter - Zanussi TD4110 Instruction Booklet

125993430.qxd 9/4/02 8:38 AM

Maintenance and Cleaning

You must disconnect the appliance from the
electricity supply, before you can carry out any
cleaning or maintenance work.

External cleaning

Use only soap and water and then dry thoroughly.
Important: do not use methylated spirit, diluents or
similar products.

Cleaning the door

Clean periodically the interior part of the door to
remove any fluff.
Accurate cleaning ensures correct drying.

Something not working?

Before contacting your local Zanussi Service Centre, please make the following checks:
• The dryer does not work:
• The dryer does not dry properly:
If, after the above checks, there is still a fault, call your local Zanussi Service Centre.
Please make sure you give the model and serial number of the appliance.
This information can be found on the rating plate (see picture on page 3).
Pagina 11
Problem

Cleaning the filter

Your dryer will only function well if the filter is clean.
The filter collects all the fluff which accumulates
during drying and it must therefore be cleaned at
the end of each programme, before removing the
laundry, with a damp cloth.
The filter cannot be removed.
Do not be alarmed by the amount of fluff. It is not
due to excessive wear caused by the dryer. All fabric
loses fluff when drying but it goes un-noticed in the
air. In a tumble dryer it simply collects in the filter.
Possible cause
• The door is open.
• The plug is not fitted into the wall socket.
• There is no electricity supply from the wall socket.
• The selector dial is not set correctly.
• The filter is clogged.
• Insufficient drying time.
• The selected cycle is not suitable for the laundry.
• The laundry has not been spun properly.
• Excessive laundry load.
• The dryer is not correctly installed.
11