Something Not Working - Zanussi ZDC37100W User Manual

Something not working

Certain problems are due to lack of simple maintenance or oversights, which can
be solved easily without calling out an engineer. Before contacting your local
Service Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes to
indicate that the machine is not working.
Once the problem has been eliminated, press the Start/Pause button to restart the
programme. If after all checks, the problem persists, contact your local Service
Centre.
Malfunction
Dryer does not work.
Drying results
unsatisfactory.
Loading door does
not close.
16
Possible cause
• Mains plug is not
plugged in or fuse is not
working correctly.
• Loading door is open.
• Have you pressed the
START/PAUSE button?
• Wrong programme
selected.
• Lint filter clogged.
• Heat exchanger clogged
with lint.
• Incorrect volume of
laundry.
• Ventilation slots in base
area covered up.
• Residue on inside sur-
face of drum or drum
ribs.
• Conductance of water at
installation site differs
from standard setting of
machine.
• Fine strainer not in
place and/or large mesh
filter not locked in place.
Solution
• Plug in at mains socket.
Check fuse in fuse box
(domestic installation).
• Close loading door.
• Press the START/PAUSE
button again.
• Select a different pro-
gramme the next time
you dry (see "Overview
of programmes" sec-
tion).
• Clean lint filter.
• Clean heat exchanger.
• Observe recommended
loading volumes.
• Uncover ventilation
slots in base area.
• Clean inside surface of
drum and drum ribs
• Re-programme stan-
dard setting for degree
of drying (see
'Programming options'
section).
• Install fine strainer
and/or snap large mesh
filter into place.