Something Not Working - Zanussi ZTA245 User Manual

125989252.qxp 2007-09-03

Something not working?

If a problem occurs, you can try to solve it yourself following the instructions below. If you call out an
engineer when one of the following problems occurs, or to repair a fault due to incorrect use, the
callout will be charged even if requested within the guarantee period.
Problem
The drier is not working
properly
The drying results are not
satisfactory
The drying cycle
exceptionally takes a long
time
The loading door
cannot be closed
The drier ends the drying
cycle automatically: END
indicator is illuminated
shortly after programme
start
14
07:51 Page 14
Possible cause
• Mains plug disconnected
• The START button has not
been depressed.
• No programme selected
• Loading door open
• Fuse or residual current cir-
cuit breaker in fuse box
(domestic installation) faulty
• Wrong programme selected
• Lint filter blocked
• Wrong filling quantity
• Laundry not sufficiently dried
• Deposit on the drum inner
surfaceor on the drum ribs
• Vented air transport disrupted
• Lint filter blocked
• Lint filter not installed and/or
filter lid not locked in position
• Too little or too dry laundry
loaded for selected pro-
gramme
Solution
• Plug in mains plug
• Press START button
• Select programme
• Close loading door
• Check fuse or residual cur-
rent circuit breaker. Faults
can be eliminated by an elec-
trical engineer
• Select another (time) pro-
gramme for the next drying
cycle
• Clean lint filter
• Observe recommended filling
quantity
• Pre-dry laundry sufficiently
• Clean drum inner surface
and drum ribs
• Straighten N- air venting
hose and/or clean air venting
ducts
• Clean lint filter
• Install lint filter and/or lock fil-
ter lid in position
• Select time programme or
higher drying level