Zanussi ZDC37100W User Manual page 17

Malfunction
When pressing a
button, the
corresponding button
flashes several times.
Drying cycle ends
shortly after
programme starts.
END light
illuminated.
Programme inactive,
Water reservoir full
light illuminated.
Drying cycle lasts an
unusually long time.
Note: After around 5
hours the drying cycle
ends automatically
(see „Drying cycle
complete")
If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the
model, serial number and purchase
date of your machine: the Service
Centre will require this information.
Possible cause
• Washing protection.
After the start of the
programme, the option
can no longer be set.
• Not enough washing
loaded or washing
loaded is too dry for
selected programme.
• Water reservoir is full.
• Lint filter clogged.
• Heat exchanger
clogged with lint.
• DELICATE button
pressed and load vol-
ume too big.
• Load volume too big.
• Laundry insufficiently
predrained.
If you call out an engineer to a fault
listed below, or to repair a fault caused
by incorrect use or installation, a
charge will be made even if the
appliance is under guarantee.
Solution
• Turn the programme
knob to "0" Set the pro-
gramme again
• Select time programme
• Empty the water reser-
voir, then start pro-
gramme with
START/PAUSE button.
• Clean lint filter
• Clean heat exchanger.
• DELICATE is only suit-
able for use with loads of
up to 3 kg!
• Reduce load volume.
• Laundry must be ade-
quately pre-drained.
Important:
17