Auto Tp Seek Function; Presetting Volume For Traffic Information/New S - Kenwood KDC-7060R Instruction Manual

If you are listening to a tape or disc w hen a traffic bulletin
begins, they w ill automatically be turned off. When the
bulletin ends or poor reception is experienced, the tape or disc
w ill begin playing again.
N OTE
Pressing the TI button w hilst in the M W/LW band automatically
sw itches reception to the FM band. How ever, the M W/LW band
is not returned to w hen the TI button is pressed again.
Sw itching to a Different Traffic Information Station:
Use the 4 / ¢ buttons to make an auto seek of the TI
stations in a certain band.
N OTE
• When you are listening to a tape or disc, you cannot change to
another TI station.
• When the auto TP seek function is turned on and reception
starts to w eaken, the tuner automatically seeks stations w ith
better reception.
• If you are tuned to a station that is not a traffic information
station itself but w hich provides EON services, you can still
have traffic information received.
• Holding the TI button dow n for one second or more w hen the TI
function is on in the disc control mode results in a change to
the frequency display of the traffic information station for five
seconds.
A ut o TP Seek Funct ion
When the TI function is on and poor reception conditions are
experienced w hen listening to a traffic information station,
another traffic information station w ith better reception w ill
be searched for automatically. This function is on, w hen unit
is first pow ered on.
Turning Auto TP Seek Function On/ Off:
1
Hold dow n the M ENU button for one second or more.
"M ENU" is displayed and the menu mode is turned on.
2
Press the ¢ button repeatedly until the Auto TP Seek
function appears in the display.
Press the 4 button to search in the other direction.
The function setting is indicated by "ATPS ON" or "ATPS OFF"
in the display, indicating that the function is on or off,
respectively.
3
Sw itching settings
Press either the AM button or FM button.
The display and setting w ill change.
If the traffic information station you are tuned to experiences
poor reception, this function automatically seeks another TP
station.
4
Press the M ENU button to end the menu mode.
Preset t ing V olum e f or Traf f ic Inf orm at ion/N ew s
Preset the volume level to be used for traffic information and
new s broadcasts.
1
Tune into the station for w hich you w ant to set the volume.
2
Adjust the volume to the desired level.
3
Hold dow n the VOL ADJ button for tw o seconds or more.
The volume level blinks once in the display to indicate that the
data has been stored.
Future traffic information/new s broadcasts are heard at the
preset level.
N OTE
• The volume cannot be low ered by this function during tuner
reception. The volume is only set w hen it is louder than the
listening volume of the tuner.
• You can arrange only to listen to traffic information or new s
bulletins w ith at preset volume w ith the volume set at
minimum.
— 17 —