Installation - Kenwood KDC-7060R Instruction Manual

2WA RN IN G
Connecting the ISO Connector (see p.38)
The pin arrangement for the ISO connectors depends on the type
of vehicle you drive. M ake sure to make the proper connections to
prevent damage to the unit.
The default connection for the w iring harness is described in 1
below . If the ISO connector pins are set as described in 2 or 3 ,
make the connection as illustrated.
1 (Default setting) The A-7 pin (red) of the vehicle' s ISO
connector is linked w ith the ignition, and the A-4 pin (yellow ) is
connected to the constant pow er supply.
Unit
Ignition cable (Red)
Battery cable (Yellow )
2 The A-7 pin (red) of the vehicle' s ISO connector is connected to
the constant pow er supply, and the A-4 pin (yellow ) is linked to
the ignition.
Unit
Ignition cable (Red)
Battery cable (Yellow )
3 The A-7 pin (red) of the vehicle' s ISO connector is not
connected to anything, w hilst the A-4 pin (yellow ) is connected
to the constant pow er supply (or both the A-7 (red) and A-4
(yellow ) pins are connected to the constant pow er supply).
Unit
Connect to a pow er source that can be
Ignition cable (Red)
turned on and off w ith the ignition key.
Battery cable (Yellow )
Inst allt ion

Installation

Accessory 3
Vehicle
A–7 Pin (Red)
A–4 Pin (Yellow )
Self-tapping
screw
(commercially
available)
Vehicle
N OTE
A–7 Pin (Red)
M ake sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (eg, the sound may skip).
A–4 Pin (Yellow )
Vehicle
2CA U TION
To attach this unit, fit it into the mounting sleeve by pressing the four
A–4 Pin (Yellow )
corners of the hard rubber frame.
Do not apply strong pressure to other sections than the corners;
otherw ise troubles such as the impossibility of opening or closing the
panel may result.
— 39 —
Firew all or metal support
M etal mounting
strap
(commercially
available)
Bend the tabs of the
mounting sleeve w ith
a screw driver or
similar utensil and
attach it in place.