Code Security Function - Kenwood KDC-7060R Instruction Manual

Code Securit y Funct ion
After a security code has been registered, pow er cannot be
restored if the battery is disconnected from the unit unless the
code is first input.
N OTE
All the steps in this procedure (1 through 7) must be completed
before the code security function can be turned on. How ever,
once the procedure is finished, it need not be repeated.
Once the code security function has been activated, "SECURITY"
disappears from the M ENU system. Note that it w ill no longer be
possible to cancel this function afterw ards.
1
Hold dow n the M ENU button for one second or more.
"M ENU" is displayed and the menu mode is turned on.
2
Press the ¢ button repeatedly until "SECURITY" appears in
the display.
Press the 4 button to search in the other direction.
3
Hold dow n either the AM or FM button for tw o seconds or
more.
"ENTER" w ill appear in the display for one second, indicating
the code setting mode has been entered. When "CODE"
appears in the display, you can start inputting the code.
4
Press the preset button and enter your security code.
Use the security code show n on your Car Audio Passport.
Example: Enter "3510" as your code, pressing the buttons as
follow s:
Step Button to press
1
#1
2 #2
3 #3
4 #4
5
Hold dow n the DISP button for three seconds or more.
The security code w ill be set.
"RE-ENTER" w ill appear in the display for one second, asking
# Times
Display
pressed
4 " 3"
6 " 5"
2 " 1"
1 " 0"
— 33 —
you to enter the code once again for confirmation. When
"CODE" appears in the display, you can start inputting the
code.
6
Press the Preset button and input the security code again.
7
Hold dow n the DISP button again for three seconds or more.
"APPROVED" w ill appear in the display, w ith the code security
function turning on. From this point on, if the unit is
disconnected from the battery, the security code must be
entered the first time that the unit' s pow er is turned on.
"ENTER" and "CODE" w ill appear in the display, asking you to
input the code.
N OTE
If you input an incorrect security code, the display ask you once
more to input the correct one. Follow the procedure in step 6
above.
If you press the RESET button or remove the battery:
The first time you turn the unit on again, "CODE" w ill appear in
the display, asking you to input the security code.
Repeat steps 6 and 7 above, and input the security code.
You can start operating the unit again w hen "APPROVED"
appears in the display.
N OTE
If you enter the w rong code, "WAITING" is displayed and you
cannot make further input of the code for a fixed interval (see
table below ), w hich grow s longer each time you enter the w rong
code.
When "CODE" is displayed, you can make input again.
Number of w rong Interval until next input
inputs
1
2
3
4
The number of w rong inputs is displayed.
is allow ed
-
5 minutes
1 hour
24 hours