Table of Contents
Advertisement
Available languages
Available languages
GB
3 Operation
1.
Switch on the thermometer by pressing the START-button
Make sure, the body temperature measurement mode
active (press the SET-button
2.
Point the sensor
forehead at a distance of around 5 to 15 cm.
If the forehead has hair, sweat or dirt on it,
remove this first so that the reading is as
accurate as possible.
3.
Press the START-button
measurement.
4.
The measurement result
second. If the acoustic signal is actived, a short beep can be
heard.
5.
If the measurement result is equal or over the adjusted fever
alarm level and the acoustic signal is activated, three beeps
will be emitted (fever alarm).
6.
The result will automatically be stored. After approx. 10 seconds
without pressing any button the device will automatically be
switched off.
3.4 Measuring the temperature of an object or of the
surrounding air
1.
Switch on the thermometer by pressing the START-button
Make sure, the surface temperature measurement mode
active (press the SET-button
2.
Point the sensor
around 5 to 15 cm. If it has water, dust or dirt on it, remove this
first so that the reading is as accurate as possible. If you want
to measure the temperature of the surrounding air, no object
should be present in a close range of the sensor
vice.
3.
Press the START-button
4.
The measurement result
second. If the acoustic signal is actived, a short beep can be
heard.
5.
The result will automatically be stored. After approx. 10 seconds
without pressing any button the device will automatically be
switched off.
20
if necessary).
at the middle of the
to start the
will be displayed after approx. 1
if necessary).
at the middle of the object at a distance of
to start the measurement.
will be displayed after approx. 1
.
is
.
is
G
of the de-
G
G
G
Advertisement
Table of Contents
