Medisana FTG Instruction Manual page 23

8. Adjust the value with the "+"
9. Press the SET-button
show "F5" and then the selected state of the backlight (ON or
OFF).
10. Adjust the value with the "+"
11. Press on the SET-button
and switch off the device. If no buttons are pressed in setting
mode for approx. 10 seconds, the device will automatically
switch off.
3.3 Measuring the body temperature
NOTES,
• The thermometer and the patient must remain in a stable
environment for at least 30 minutes before measuring the
temperature.
• Do not take a baby's temperature during or directly after
breastfeeding.
• Do not use the thermometer in damp environments.
• Patients should not drink or eat directly before or during a
measurement, and they should avoid any physical
exertion.
• Clean the area where you are taking the temperature and
remove any dirt, hairs or sweat before moving the

sensor to the measuring position.
• Do not remove the thermometer from the measuring
position until it has beeped to signal the end of the
reading.

• If the sensor
clean it with a cotton bud dipped in cleaning alcohol
before putting the thermometer away.
• Always take the temperature in the same place, because
the readings will vary in different environments.
• A control measurement using a conventional
thermometer is recommended in the following cases:
1. If the reading is surprisingly low,
2. For new-born infants up to 100 days old,
3. For children under three years of age who have a
weakened immune system or who react unusually in
the presence or absence of fever,
4. If you are using the thermometer for the first time or
want to familiarise yourself with it.
The thermometer has been clinically tested, and its safety
and accuracy inspected and confirmed, provided it is used
in accordance with these instructions.

and "-"

again. Now the display will shortly

and "-"

once again to leave the setting mode
for the most accurate readings:
becomes dirty during or after a reading,
3 Operation

buttons.

buttons.
GB
G
G
G
19