There Is A Demanding Or Important Guest That Wants To Be Able To Set Room Target Temperature To A Higher Or Lower Value Than What Is Currently Selectable On The E7W - Honeywell INNCOM e7w Troubleshooting Manual

There is a demanding or important guest that wants to be able to set Room Target
temperature to a higher or lower value than what is currently selectable on the e7w.
Solution:
Place the room HVAC controller into "Limited Energy Management" (LEM) mode.
Then Inncom thermostat/HVAC partner to the e7w supports a "Limited Energy Management" mode where the
thermostat turns off most energy savings algorithms and expands the guest selectable upper and lower target
temperature range. This can be enabled in a room that has a demanding guest that requires more flexible room
temperature control than what is normally allowed for a room.
LEM mode in the e7w HVAC partner can be enabled or disabled from the e7w using a 3 button sequence.
To Enable LEM mode in the HVAC partner from the e7w :
1. Press and Hold the Mode button
2. Press and Release the Fan button
3. Press and Release the Up Arrow button
4. Release the Mode button
5. - - - followed by LE.n (LEM) will appear on the e7w display, indicating the command to enable
LEM mode for 72 hours was sent to the e7w HVAC partner.
Note: LEM mode in the HVAC partner will automatically turn OFF after 72 hours. In thermostats/HVAC
controllers that have been shipped recently (contact Inncom for details) , LEM mode will
automatically clear when the room is Checked-Out from the front desk (if the hotel is networked
with a PMS system installed).
To manually Disable LEM mode in the HVAC partner from the e7w :
1. Press and Hold the Mode button
2. Press and Release the Fan button
3. Press and Release the Down Arrow button
4. Release the Mode button
5. - - - followed by nO.r (normal mode) will appear on the e7w display, indicating the command to
disable LEM mode was sent to the e7w HVAC partner.
25 of 47
Honeywell Restricted
13 April 2020
Version 9.0