Safety Instructions, Protective Measures And Guidelines; Important Instructions; Qualified Personnel; Maintenance - igus Motion Plastics dryve D1 Manual

Safety Instructions, Protective Measures and Guidelines

1 Safety Instructions, Protective Measures and Guidelines

1.1 Important Instructions

Read this manual carefully before operating the dryve D1 motor control system. Familiarise with the safety instructions and
ensure that the required safety measures are followed.
This manual was created according to the best of our knowledge and belief. It is used for technical documentation and for
assisting the user during the initial operation. The warnings, cautions and instructions issued by igus
motor control system must in any case be passed on to the end user if the dryve D1 motor control system is used as part of an
overall system.
®
igus undertakes warranties only for igus
manual. The guarantee covers only the replacement or repair of a defective dryve D1 motor control system. There is no liability
for consequential damage and consequential errors. The igus
dryve D1 motor control system into the overall system. The responsibility for it lies with the plant designer or the end user.
Please observe the instructions under "Qualified Personnel". The company igus
damage to property resulting from misuse or unauthorised technical modification of the dryve D1 motor control system.
®
The igus GmbH reserves the right to make changes and improvements to the product or the technical documentation at any
time without prior notice.
The dryve D1 motor control system must only be used if:
- All information and safety instructions in this manual have been observed.
- The control system has been properly installed in a control cabinet in accordance with the instructions under
Installation (p.17)
- No changes have been made to the dryve D1 motor control system and it is in a technically flawless condition.
- The operating limits that are specified in

1.2 Qualified Personnel

The operation of the product must only be carried out by qualified personnel.
- The personnel must have read and understood this manual and any other additional documentation that exists
- The personnel must be familiar with all relevant applicable standards, provisions and accident prevention regulations.
- The personnel must be able, due to their training, to anticipate or recognise any hazards that may arise when using the
control system.
- The personnel must ensure the safety of persons and objects when using the motor control system in the overall
system.

1.3 Maintenance

The dryve D1 is maintenance-free Apart from the connectors, the dryve D1 does not contain any components that the user can
replace from the outside. Never open the motor control system. If hardware problems occur, please get in touch with
service (p.101).
Opening the housing will void the warranty.
Sebastian Probst
Operating Manual dryve D1, ST-, DC-, EC/BLDC-Motor Control System - V2.4
®
products in accordance with the standards, norms and specifications given in this
®
GmbH does not take any responsibility for the integration of the
Technical Data (p.14)
®
assumes no liability for personal injury or
are complied with.
®
regarding the dryve D1
Electrical
Customer
5/121