Advertisement
Gas and Air Sensors
aSENSE GH (Disp) RL
CO
/ temperature transmitter with relay
2
4
1
3
1 Back plate
2 PCB (mounted in the box at delivery)
3 PG7 Cable entry bushing
4 Attachment loop
If the connection cables are drawn through a conduit the conduit must be
sealed.
Air of different temperature may otherwise disturb the temperature
measurements.
Installation Manual
for use in greenhouses
6
7
5 Snap-in lid
6 Lid locking screw (not shown)
7 Temperature sensor
2
5
Document
Rev
IMA 279
3
Page
1 (4)
Advertisement
Table of Contents
Related Manuals for SenseAir aSENSE GH (Disp) RL
Summary of Contents for SenseAir aSENSE GH (Disp) RL
- Page 1 Gas and Air Sensors Installation Manual aSENSE GH (Disp) RL / temperature transmitter with relay for use in greenhouses 1 Back plate 5 Snap-in lid 2 PCB (mounted in the box at delivery) 6 Lid locking screw (not shown) 3 PG7 Cable entry bushing...
- Page 2 If analogue output is connected to a controller same ground reference has to be used for aSENSE GH (Disp) RL unit and for control system! If different transformers are used, special precautions need to be taken.
- Page 3 (halfwave rectifier). A single transformer may be used for the entire system. Note 2: aSENSE GH (Disp) RL can deliver a voltage or a current loop for Out(1) / Out(2). To change between voltage and current output mode the hardware jumpers are used. There is one jumper for Out(1) and one for Out(2), so that one output can be a voltage output and the other a current output.
- Page 4 Dimensions and holes 85 (3,35) 38 (1,5) 10 (0,39) 40 (1,57) OOO «Измеркон» 196240, Санкт-Петербург Пулковское шоссе, дом 9, корпус 3 Тел./Факс: +7 812 309 56 05 Тел.: +7 812 696 00 06 +7 495 721 88 93 Mail: office@izmerkon.ru Document Page Web: http://www.izmerkon.ru...
Need help?
Do you have a question about the aSENSE GH (Disp) RL and is the answer not in the manual?
Questions and answers