SenseAir aSENSE Ind Installation Manual

Co2 / temperature transmitter mounted in industrial housing

Download this manual

1 Wall plate

2 PCB (Factory supplied mounted in box)

3 Temperature sensor

4 Hole for wall plate hooks

Installation Manual

aSENSE Ind

CO 2 / temperature transmitter

mounted in industrial housing

5 Snap-in lid

6 Locking screw of the lid (not shown)

7 PG9 cable entry bushing

8 Air holes

Need help?

Do you have a question about the aSENSE Ind and is the answer not in the manual?

Page 1 Installation Manual aSENSE Ind CO 2 / temperature transmitter mounted in industrial housing 1 Wall plate 5 Snap-in lid 2 PCB (Factory supplied mounted in box) 6 Locking screw of the lid (not shown) 3 Temperature sensor 7 PG9 cable entry bushing...
Page 2 9 Lidlocking screw 10 Wall plate 11 Screw to hold the wall plate 12 Drill marks for cable entry bushings Dismounting the wall plate The sensor is delivered with the wall plate mounted. The wall plate has to be removed before the sensor is mounted onto the wall.
Page 3 (halfwave rectifier). A single transformer may be used for the entire system. Note 2: aSENSE Ind can deliver a voltage or a current loop for Out(1) / Out(2). To change between voltage and current output mode the hardware jumpers are used. There is one jumper for Out(1) and one for Out(2), so that one output can be a voltage output and the other a current output.
Page 4 The dimensions of the sensor in mm and (inches) (2,48)63 42(1,65) Ø5(0,20) Ø5(0,20) 41(1,61) Ø5(0,20) 82(3,23) The measurements of the wall plate in mm and (inches) ® Senseair AB (headquarter) Stationsgatan 12 Phone: +46-(0)653 - 71 77 70 Box 96 E-mail: info@senseair.com 824 08 Delsbo SWEDEN Web site:...