Safety Instructions; General Safety Notes - Siemens 1FK7 Series Operating Instructions Manual

Safety instructions

2.1

General safety notes

Safety and commissioning information for converter-fed low-voltage three-phase motors
All activities associated with transporting, connecting, commissioning, and maintaining the
motors must be carried out by properly trained, responsible personnel (observe DIN EN
50110-1; IEC 60364).
Failure to follow proper procedures may result in injury or material damage.
Special versions and design versions may differ with respect to certain technical aspects. If
in doubt, you are strongly advised to contact the manufacturer, specifying the type
designation and serial number (see rating plate), or arrange for any maintenance work to be
carried out by the SIEMENS Service Center.
Systems and machines with converter-fed low-voltage three-phase motors must fulfill the
protective requirements of the EMC Directive.
The machine manufacturer is responsible for ensuring that installation is carried out properly.
The signal and power cables to the motor must be shielded.
The information provided by the converter manufacturer regarding EMC-compliant
installation must be observed.
Intended use
These motors are designed for use in industrial or commercial systems. They comply with
the EN 60034-1 standards and the relevant associated sections.
It is forbidden to install them in hazardous areas unless they are explicitly designed for this.
If more stringent requirements are necessary in special cases (e.g. shock-hazard protection
in non-commercial applications where children are likely to be present), the customer must
implement the relevant measures to ensure that these requirements are fulfilled.
Any alternative data specified on the rating plate must be taken into account. The conditions
at the installation location must comply with the rating plate specifications.
The motors are designed for use in sheltered areas under normal climatic conditions, such
as those found in production environments.
Synchronous Motors 1FK7
Operating Instructions, 03/2011, 610.40700.40c
DANGER
WARNING
2
7