Appendix 3 Adding A New Remote Control; Pairing A New Rc:199 Remote Control With The Receiver Unit - Cirrus Research Trojan Lite User Manual

Page 28 CK:199L Trojan LITE Noise Nuisance Recorder User Manual Guide

Appendix 3 Adding a new remote control

The Trojan Noise Nuisance Recorder can support up to 40 individual RC:199 Remote
LITE
Control Units.
This allow for new remote controls to be added or old units replaced.
To add a new remote control to the system, it must be paired with the receiver (the
control box in the case with the status indicator lights).

Pairing a new RC:199 Remote Control with the Receiver Unit

To add a new RC:199 Remote Control, you will need a Paper Clip or other similar small
pointer.
1. Power up the Trojan LITE with ZE:199 fitted and a 12V exterior power supply.
Ensure that the Trojan is not recording.
LITE
There is a small 1mm diameter hole on the main ZE:199 panel above the hole for the
USB cable (see below)
Use a small device such as a paper clip or other blunt device with a diameter of less
than 1mm and length of end over 4mms to gently action this switch.