Cirrus Research Trojan Lite User Manual page 29

CK:199L Trojan LITE Noise Nuisance Recorder User Manual Guide Page 29
3. Insert the paper clip to push the micro-switch briefly.
The Blue LED will flash when the micro-switch is pushed then once when switch
released.
4. Push again.
The Blue LED will flash when the micro-switch is pushed then twice when the switch is
released.
5. Push again.
The Blue LED will flash when the micro-switch is pushed then three times when the
switch is released.
6. Push the STOP button on the RC:199 Remote Control.
The Blue LED will then illuminate. Press the STOP button again. The Blue LED will then
go out and then flash once to indicate learning is complete for STOP.
7. Push the micro-switch briefly.
The Blue LED will flash when the micro-switch is pushed then once when switch is
released.
8. Push again.
The Blue LED will flash when the micro-switch is pushed then twice when the switch is
released.
9. Push again.
The Blue LED will flash when the micro-switch is pushed then three times when the
switch is released.
10 Push again.
The Blue LED will flash when the micro-switch is pushed then four times when the
switch is released.
10. Push the RECORD button on the RC:199 Remote Control.
The Blue LED will then illuminate.
Press the RECORD button again.
The Blue LED will then go out and then flash once to indicate learning is complete for
RECORD.
11. Repeat the above procedure for each new transmitter.
Now test each transmitter to ensure the STOP and RECORD function works on the
Trojan LITE (a blue line on time history as well as the Red Led going on and off.)