Configure The Alg - Zte ZXHN H2640 Maintenance Management Manual

ZXHN H2640 Maintenance Management Guide(TIM)
Parameter
Name
Target
Ingress
Prefix
Service Type
6. Click Apply button to apply the changes.
Configuring the Remote Service Port Control-IPv4
7. Click Remote Service Port Control - IPv4 to open Remote Service Port Control -
IPv4 page, see
Figure 4-22 Remote Service Port Control - IPv4 Page
Table 4-13
Table 4-13 Parameter Descriptions for the Remote Service Port Control - IPv4
Parameter
HTTPS
8. Click Apply button to apply the changes.

4.4.4 Configure the ALG

Abstract
The section describes how to configure ALG. ALG provides the relevant parameters of
security configuration function.
4-26
Description
Click Off to disable the function.
Name of the Service Control item.
The name must be specified.
Specify to discard or permit the data packages.
Specify the data stream inbound direction, and this parameter must
be specified.

If the Ingress is WAN_All, all the WAN connection can access
ZXHN H2640.

If the Ingress is LAN, the LAN side can access ZXHN H2640.

If the Ingress is a WAN or Route_3G connection, the connection
selected can access ZXHN H2640.
IPv6 address prefix.
Type Specify the service that is permitted or denied to access.
Figure 4-22.
lists the remote service port control - IPv4 parameters.
Description
The remote service port control of HTTPS.
SJ-20200714160642-002 | 2020-07-27(R1.0)