Initialize Setting Conditions - Teac DS Series Instruction Manual

8.3 Initialize Setting Conditions

You can initialize the setting conditions to the default (factory) settings, and restart the system.
Controls by Using Browser
The initialization process turns off and boots the system automatically. To enable the controls
from the browser after the initialization process, manually turn the power off and on again to
reflect the changes on the network settings by confirming the IP address.
1.
2.
3.
Move the cursor to [Yes] to execute the initialization. If you do not initialize the system settings,
move the cursor to [No].
4.
5.
6.
enter http://xxx.xxx.xxx.xxx/ds.html to re-connect.
Default Settings
Each setting condition is initialized as follows;
Page 56
Display the <PARAMETER> menu.
Move the cursor to [DEFAULT] by pressing the down keys.
Press the ENTER key to go to the <DEFAULT> menu.
Press the ENTER key to start initialization of the system settings by displaying the following.
The system automatically boots up after the initialization.
To control the system by using the browser, confirm the IP address of the DS system, and
Sampling Frequency
Number of Recording Channels
Recording Target Device
Monitor Channel
Record Mode
Input Range
PA Amp Input Mode
Zero Shift
Voice Memo Recording
Speaker Output
Network Setting
File Name
NTP Server Address
1 MHz
16 channels
Internal HDD
Channel 1
Normal
+/- 1 V
DC
+/- 0 %
OFF
OFF
DHCP ENABLE
DEFAULT_0001
131.107.1.10 (time-nw.nist.gov)