Change Param> Menu; Use Dhcp Client Function - Teac DS Series Instruction Manual

12.1 <CHANGE PARAM> Menu
You can set the DHCP client function and enter the IP address and other network parameters.
You can decide the entries here by using the <SET NETWORK> menu.

12.1.1 Use DHCP Client Function

If the DHCP server is in a network where you connect the DS unit, you can use the DHCP client
function of the DS unit that makes it easy to connect to the network.
1.
2.
PARAM> menu is displayed.
3.
4.
client function) or [DISABLED] (not to use the DHCP client function). When you use the fixed IP
address setting (explained later), select [DISABLE].
5.
6.
If you do not want to enter the selection, press the STOP key. The selection is not effective.
Then return to the <CHANGE PARAMETER> menu.
Display the <NETWORK> menu.
Press the ENTER key by confirming that the cursor is in [CHANGE PARAM]. The <CHANGE
Press the ENTER key by confirming that the cursor is in [DHCP].
Move the cursor by using the up and down keys to select either [ENABLED] (use the DHCP
Press the ENTER key to go to the confirmation display.
Press the ENTER key to enter the selection. The <CHANGE PARAM> menu is displayed.
DS Series Instruction Manual 2006.12
Page 73