Output Range Setting - Teac DS Series Instruction Manual

10.4 Output Range Setting

You can set the output range of each channel.
1.
(If the system is not in ready state, press the STOP key a few times depending on the hierarchy
of the current menu to move to ready state.)
2.
3.
4.
5.
6.
can set all effective channels with the same output range at [ALL].
Press the left and right keys to select the desired output range.
7.
The <PLAYBACK> menu is displayed.
If you do not want to decide the selection, press the STOP key. The selection is not effective.
Then return to the <PLAYBACK> menu.
Confirm that the system is in ready state (<READY> display).
Press the ENTER key to display the main menu <MENU>.
Press the ENTER key to go to <PLAYBACK> by confirming that the cursor is in [PLAYBACK].
Move the cursor to [RANGE] by pressing the down keys.
Press the ENTER key to go to <PLAY RANGE>.
Move the cursor to the channel to set its input range by pressing the up and down keys. You
After setting the output ranges of all channels, press the ENTER key to decide the selections.
DS Series Instruction Manual 2006.12
Page 67