CONTROL SYSTEM
ADJUSTING THE START-IN-GEAR
PROTECTION DEVICE
1. Check:
Start-in-gear protection device
operation
Incorrect
2. Adjust:
Start-in-gear protection cable.
Adjusting steps:
(1)Set the shift lever in the neutral
position.
(2)Loosen the locknut 1.
(3)Adjust the adjusting nut 2 so that the
a
point
on the wire connector 3
aligns with the mark
cover.
(4)Tighten locknut 1.
NOTE:
Shift the shift lever into neutral and make
sure the starter can be pulled. If it cannot
be pulled, repeat the above procedure.
3-8
Adjust.
b
on the starter