Installing The Manual Starter; Adjusting The Start-In-Gear Protection Cable; Measuring The Starter Rope - Yamaha F4B Service Manual

16. Align the protrusion g on the starter
plunger b and the mark h on the
manual starter i.
17. Pull the starter handle o several times to
check that the sheave drum turns
smoothly and to check the starter rope e
for slack.
i
o
e

Installing the manual starter

1. Install the manual starter a.
2. Connect the start-in-gear
cable b.
Adjusting the start-in-gear
protection cable
Make sure to remove the clip from the
engine shut-off switch before checking
the start-in-gear protection.
1. Move the shift lever to the N position.
2. Loosen the start-in-gear protection cable
locknut a, and then align the protrusion
b on the starter plunger a and the mark
c on the manual starter b.
b
b
g
h
protection
b
a
3. Tighten the start-in-gear protection cable
locknut a to the specified torque.
b
Start-in-gear protection cable locknut a:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
4. Move the shift lever to the F or R position.
5. Check that the starter handle cannot be
pulled.

Measuring the starter rope

1. Pull the starter handle a to extend the
starter rope b completely, and then
measure the starter rope extended
length a.
a
a
b
Starter rope extended length a:
1430.0–1570.0 mm (56.3–61.8 in)
Manual starter
a
0
b
c
1
a
2
3
4
5
6
7
8
9
10
A
7-10