Using The Built-In Timer; Timer Play - Yamaha GX-500RDS Owner's Manual

1 2 3
DISC DISC DISC DISC CHANGE
PTY SELECT PRESET/ TUNING/ BAND
YMERSION B.BOOST MUSIC
HOUR
FREQ PS/PTY/RT/CT
RANDOM
HOUR
MODE DOLBY NR REC/PAUSE AUTO/MANUAL
TIMER
TIMER
DIRECTION
1 2 3
1 2 3
6 7 8
6 7 8
A B C
TIME PROG R. TIME
MODE REPEAT RANDOM
DISC SKIP
TUNER CD
REC/PAUSE
TAPE
YMERSION BASS BOOST
INPUT
POWER SLEEP
POWER
/I

Using the built-in timer

OPEN / CLOSE
A/B/C/D/E
VOLUME
DOWN UP
INPUT
MIN
INPUT INPUT
MODE–PTY SEEK– START
REPEAT TIME
MIN
MEMORY DISPLAY
DISPLAY
TIME ADJ
STANDBY/ON
STANDBY/ON
4 5
4 5
PRESET
9 0
D E
+
EDIT I0
TUNER
DIRECTION
INPUT
MUSIC
VOLUME

Timer play

By using the built-in timer, you can set the time when this
system turns on and a source play begins, and the time when
this system will be set to the standby mode automatically.
1
Press DISPLAY.
Whenever DISPLAY is pressed, the display mode changes
as follows.
1 Current time (TIMER on/off mode)
2 Source selecting mode (TAPE, TUNER, CD)
3 ON TIME/Time setting mode
4 OFF TIME/Time setting mode
5 Normal display mode
Note
The display mode will change in about 8 seconds. If the
mode is changed before the setting is completed, call the
mode again by pressing DISPLAY once or more.
1
Current time
Make sure that the current time is correct, and press
TIMER so that "TIMER" lights up on the display.
2
Source selecting mode
Select the source to be played with INPUT
3
ON TIME/time setting mode
["ON TIME" appears on the display, and soon it is
changed to a time setting mode.]
Set the time when you want to begin the timer play.
Press HOUR and set the hour.
Press MIN and set the minute.
4
OFF TIME/time setting mode
If necessary, set the time when you want to finish the
timer play in the same way as you did in step
do not set the time, it will be automatically set so that the
timer play finishes after 1 hour.
2
Press TIMER to complete the timer play setting.
This system turns into the standby mode.
* The STANDBY and TIMER indicators light up.
If you will continue using this system, press STANDBY/ON
to turn on this system.
To cancel the timer play setting
Press DISPLAY, and then press TIMER so that the TIMER
indicator goes out.
Note
Unless there is a power failure for more than 5 minutes, the
set time will be retained until it is reset.
or .
3
. If you
E-33