Using The Built-In Timer; Timer Play - Yamaha GX-505 Owner's Manual

Using the built-in timer

STANDBY/ON
DISC 1 DISC 2 DISC 3
3–DISC CD CHANGER
STANDBY
STANDBY
/ON
TIMER
INPUT PRESET/TUNING/BAND A/B/C/D/E
/
BASS TREBLE
REC/ AUTO/
PHONES
MODE DOLBY NR PAUSE MANUAL MEMORY
TIMER TIME ADJ
TIMER
HOUR
POWER
1 2 3
1 2 3
4 5 6
4 5 6
7 8 9
7 8
+ I0
0 TUNER
PRESET PRESET
TIME PROG R.TIME
A B C
EDIT DISC SKIP MODE
D E
CD
/
DIRECTION
TAPE
REC/ PAUSE
YMERSION MUSIC
SLEEP INPUT
VOLUME

Timer play

INPUT
DISC CHANGE OPEN/CLOSE
By using the built-in timer, you can set the time when this system
turns on and a source play begins, and the time when this system is
set to the standby mode.
DIGITAL AUDIO
1
Press DISPLAY.
YMERSION B.BOOST MUSIC
Whenever DISPLAY is pressed, the display mode changes as
VOLUME
follows.
UP
DOWN
RANDOM REPEAT TIME DISPLAY
HOUR MIN
MIN
DISPLAY
POWER
Note
(standby/on)
The display mode will change in about 8 seconds. If the mode is changed
before the setting is completed, call the mode again by pressing
DISPLAY once or more.
1 Current time
2 Source selecting mode
3 ON TIME/time setting mode
4 OFF TIME/time setting mode
2
Press TIMER to complete the timer play setting.
This system turns into the standby mode.
* The STANDBY and TIMER indicators light up.
If you will continue using this system, press STANDBY/ON to
turn on this system.
INPUT
To cancel the timer play setting
Press DISPLAY, and then press TIMER so that the TIMER
indicator goes out.
Note
Unless there is a power failure for more than 5 minutes, the set time will be
retained until it is reset.
1 Current time (TIMER on/off mode)
2 Source selecting mode (TAPE, TUNER, CD)
3 ON TIME/Time setting mode
4 OFF TIME/Time setting mode
5 Normal display mode
Make sure that the current time is correct, and press TIMER
so that "TIMER" lights up on the display.
Select the source to be played with INPUT
INPUT on the remote control).
["ON TIME" appears on the display, and soon it is changed
to a time setting mode.]
Set the time when you want to begin the timer play.
• Press HOUR and set the hour.
• Press MIN and set the minute.
If necessary, set the time when you want to finish the timer
play in the same way as you did in step 3. If you do not set
the time, it will be automatically set so that the timer play
finishes after 1 hour.
or (or
-31
E