Timing The First And Second Place Finishers; Timer; Setting The Countdown Start Time; Using The Timer - Casio 5631 Operation Manual

Timing the First and Second
Place Finishers
1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
2.
Use the operations below to measure
elapsed time.
E
Start
B
1st Finisher*
E
2nd Finisher*
* Displays the time of the first finisher.
Elapsed time is shown in 1/1000-
●
second units for the first hour of the
measurement session. After the first
hour, elapsed time is shown in 1/10-
second units.
First hour After first hour
Minutes, seconds, Hours, minutes,
1/1000 seconds seconds, 1/10 seconds
3.
Press (B) to display the time of the second
place finisher.
4.
Press (B) to reset the stopwatch to all
zeros.

Timer

The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper is muted in the cases described
●
below.
When battery power is low
ー
Operation Guide 5631
Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.

Using the Timer

l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the hour digits
start to flash.
This causes the hours digit to flash.
Hours
3.
Use (B) and (E) to change the timer hours
setting.
4.
Press (D).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (E) to change the minutes
setting.
6.
Press (D).
This causes the seconds digits to flash.
7.
Use (B) and (E) to change the seconds
setting.
8.
Press (A) to exit the setting screen.
Note
You can also use G-SHOCK
●
Connected to configure timer settings.
Seconds
Using the Timer
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Use the operations below to perform a
timer operation.
E
Start
(Countdown starts)
E
Pause
E
Resume
(Time up)
A beeper will sound for 10 seconds to
●
let you know when the end of a
countdown is reached.
You can reset a paused countdown to
●
its start time, by pressing (B).
3.
Press any button to stop the tone.
Alarms and Hourly Time
Signal
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
The alarm sound is muted in the cases
●
described below.
When battery power is low
ー
When watch is at Level 2 power saving
ー
Power Saving Function
l
11