Cleaning And Maintenance; Warranty - Ferm PSM1027 Original Instructions Manual

Removing
• Open the sanding paper clamps (4).
• Remove the sanding paper (8) from the
sanding pad (3).
• Close the sanding paper clamps (4). Mounting
and removing the sanding paper (hook-and-
loop system) (fi. B2)
Mounting
• Mount sanding paper (8) with the required
grain size onto the sanding pad (3). Make
sure that the perforation in the sanding paper
(8) corresponds with the perforation on the
sanding pad (3).
Removing
• Remove the sanding paper (8) from the
sanding pad (3).
USE
Switching on and off (fig. A)
• To switch on the machine, press the on/off
switch (1).
• To switch the machine to continuous mode,
keep the on/off switch (1) pressed and
simultaneously press the lock-on button (2).
• To switch off continuous mode, press the on/
off switch (1) again.
• To switch off the machine, release the on/off
switch (1).
Dust extraction (fig. C)
• Insert the dust extraction adapter (9) into the
dust extraction connection (7).
• Connect the hose of a vacuum cleaner to the
dust extraction adapter (9).
Hints for optimum use
• Clamp the workpiece.
• Firmly hold the machine with both hands.
• Switch on the machine.
• Place the sanding pad with sanding paper on
the workpiece.
• Slowly move the machine over the workpiece,
firmly pressing the sanding pad against the
workpiece.
• Do not apply too much pressure on the
machine. Let the machine do the work.
• Switch off the machine and wait for the
6
machine to come to a complete standstill
before putting the machine down.

CLEANING AND MAINTENANCE

Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
• Regularly clean the housing with a soft cloth.
• Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
• Regularly clean the sanding pad to avoid
inaccuracies during use.
Replacing the sanding paper (fig. B)
• To remove the old sanding paper (8), proceed
as described in the section „Mounting and
removing the sanding paper".
• To mount the new sanding paper (8), proceed
as described in the section „Mounting and
removing the sanding paper".
Replacing the sanding pad (fig. D)
In case of wear, the sanding pad must be
replaced.
• If necessary, remove the sanding paper.
• Loosen the screws (10) from the sanding pad
(3).
• Remove the old sanding pad (3).
• Mount the new sanding pad (3).
• Tighten the screws (10) to the sanding pad (3).

WARRANTY

Consult the enclosed warranty terms.