Table of Contents
Advertisement
Safety Information
Install Sun StorEdge 6120 arrays in accordance with the local safety codes and
regulations at the facility site. Make sure you read and follow the safety precautions
in the Sun StorEdge 6120 Array Regulatory and Safety Compliance Manual before
installing an array configuration.
The following sections contain additional safety information for the local facility:
"Handling Precautions" on page 3
I
"Placement of a Sun Product" on page 4
I
Note – Do not make mechanical or electrical modifications to the equipment. Sun
Microsystems, Inc. is not responsible for regulatory compliance of a modified Sun
product.
Handling Precautions
Caution – A fully configured rackmounted array system in a cabinet can weigh in
excess of 1400 pounds (627 kg). Ensure that all surfaces this system will move over
can withstand this load.
The cabinet is equipped with wheels so that you can move it. Use enough personnel
when moving the cabinet, especially on sloping loading docks and ramps, to gain
access to a raised computer room floor. Move the cabinet slowly and deliberately,
and make sure that the floor is free from foreign objects and cables that the cabinet
could roll over.
Caution – To avoid injury, wear protective footwear when moving a cabinet.
Install the cabinet on a level surface. At each corner, on the base of the cabinet, are
adjustable non-skid pads. These must be extended when the cabinet is installed to
stop the cabinet from rolling around. These pads are not to be used to level the
cabinet.
For more information on moving and installing a Sun StorEdge Expansion Cabinet,
refer to the cabinet documentation available on the Sun documentation web site:
http://www.sun.com/documentation
Preparing the Site
3
Advertisement
Table of Contents
