Troubleshooting Installation Problems - Bully Dog GT GAS Manual

TUNING VEHICLE

TROUBLESHOOTING INSTALLATION PROBLEMS

ERROR DURING INSTALLATION
1. Make note of the code number and all information displayed on the screen.
2. Disconnect and update your GT Gas.
3. Make sure that you have disconnected all aftermarket electronics and completed all of the important preparation steps.
4. Try to install the download again.
5. If the error occurs again, contact technical support.
This troubleshooting procedure applies to all errors, including the following code#s: 0, 141, 325 (on a 2011 Duramax), 358, 393
GETS STUCK ON "TURN KEY TO RUN"
1. Make sure that the key is turned as far as possible without turning the engine on.
2. Turn the key to the Off position, then turn it back to the On position.
3. Jiggle the key.
4. Disconnect the GT Gas.
5. Update the GT Gas if this has not already been done.
6. Reconnect the GT Gas.
7. Make sure that all aftermarket electronics are disconnected from the vehicle.
8. Pull fuses if necessary for your vehicle.
9. Try to install the download again.
10. If the error occurs again, contact technical support.
GT GAS FREEZES IN THE MIDDLE OF THE DOWNLOAD.
Try connecting a battery charger to maintain voltage. (This step can solve many problems, even if your battery is
new and fully charged).
(940) 783-9915 | www.bullydog.com
28