Step 4: Attach Wheels - Ranger G4RANQ Instructions For Assembly And Use

Assembly instructions (continued)
STEP 3: Attach RIGHT Side Beams and Drip Tray Support.
WHAT YOU NEED:
Two x M6*16mm screws (AA)
One x Side Beam (R) (no holes)
One x Drip Tray Support (N)
One x Right Front Leg (L)
One x Right Back Leg (M)
One x Cylinder Support Beam (Q) (with two holes)
RF = RIGHT FRONT
RB = RIGHT BACK
Loosen Six pre-assembled M6*16mm screws (AA) from "X" positions, and leave the screw heads
protruding approximately 5mm.
Hang Side Beam (R) and Drip Tray Support (N) to Right Front Leg (L) and Right Back Leg (M), then
tighten the screws at the "X" positions. Attach the Cylinder Support Beam (Q) in the same way using two
M6*16mm screws (AA) from the hardware pack, and fastening those two screws into the "Y" positions.
Note: Be sure part (R) (Q) and (N) are installed correctly as shown. Part Q should have the two holes
facing away (so not visible in the diagram below.) Tighten all screws.
X
Y

STEP 4: Attach Wheels

WHAT YOU NEED:
One x M10 Flange nuts (BB)
One x Axle (S)
Two x Wheels (TT)
Thread the Axle (S) through Two Wheels (TT),
Right Front Leg (L), Right Back Leg (M), then
fasten M10 Flange nuts (BB) as shown.
Use pliers to hold the axle firm while tightening the
nuts.
Page 9
N
X
Y
Q
X
X
M
X
X
R
AA
X
Y
X L
X
X
X
L
M
Q
TT
BB
S