Ranger G4RANQ Instructions For Assembly And Use page 10

Assembly instructions (continued)
STEP 5: Attach Rear Beam
WHAT YOU NEED:
One x Rear Beam (P)
Loosen Four pre-assembled M6*16mm screws
(AA) from Left Back Leg (K) and Right Back Leg
(M), leave the screw heads protruding
approximately 5mm.
Hang Rear Beam (P) onto Left & Right Back Legs
on the screws and tighten loosely.
STEP 6: Attach Front Legs and Front Panels
WHAT YOU NEED:
Two x Front Panels (I)
Loosen Eight pre-assembled M6*16mm screws (AA) from Left Front Leg (J) and Right Front Leg (L),
leave the screw heads protruding approximately 5mm.
Attach Two Front Panels (I) to the cart and firmly fasten the pre-assembled screws as shown. Then
firmly tighten all the screws on the rear beam. Check all screws are tightened firmly.
L
Page 10
J
I
K
K
P
P
I
I
M
M