Table of Contents
Advertisement
Lighting and controlling the bbq
LIGHTING INSTRUCTIONS
After confirming there are no leaks:
1. Open the hood of the barbeque while lighting the main burners.
2. Turn all the control knobs clockwise to OFF position.
3. Connect the regulator to the gas bottle. Turn the gas supply ON at the gas cylinder.
4. Push IN selected burner control knob and keep pressing IN whilst turning anti-clockwise to
the HIGH position (a clicking sound is heard). This should light that burner. Observe if the burner
is lit, if the burner is not lit, repeat this step once.
5. If the burner has not lit after retrying once, turn the control knob OFF wait five minutes and
repeat step 4.
6. If the burner still does not light, light the appliance with a lit match held next to the burner,
consult your store of purchase if necessary to service the ignition .
Warning: If the burner completely fails to ignite, turn the control knob clockwise to OFF and also
turn the gas cylinder valve OFF. Wait five minutes before attempting to relight with LIGHTING
INSTRUCTIONS from STEP 1.
CONTROLLING THE MAIN BURNER FLAMES
Adjust the heat by turning the knob between the HIGH and LOW positions.
Light individual main burners in the same way as above.
To turn the complete barbeque OFF, turn the cylinder valve or regulator switch to the OFF
position and then turn all the control knobs on the appliance clockwise to the OFF position.
CONTROLLING THE FLAMES
The knobs have three basic positions OFF, LOW & HIGH. You can achieve any flame height
between LOW and HIGH by rotating the knob between these two positions.
Checking the Flames:
Look underneath the barbeque so that you can see the flames.
They should be a soft blue colour with yellow tips. If the flame appears too yellow or smoky, you
should consult your retailer before further use.
Special note: "Blowback" is a situation where the flame burns inside the burner, towards the
front. It can be recognised by a sharp roaring sound coming from the burner. It is not dangerous
unless it is allowed to persist. If this occurs, simply turn the burner control clockwise to OFF, wait
a few seconds, then relight.
Page 17
Advertisement
Table of Contents
