What You Need - Ranger G4RANQ Instructions For Assembly And Use

Assembly instructions
STEP 1: Attach LEFT Leg End Caps

WHAT YOU NEED:

One x Left Back Leg (J)
One x Left Front Leg (K)
Two x Leg End Caps (H)
LF = LEFT FRONT
LB = LEFT BACK
Put Left Back Leg (J) and Left Front Leg (K) into
Leg End Caps (H) as shown.
STEP 2: Attach LEFT Side Beam and Drip Tray Support.
WHAT YOU NEED:
Two x M6*16mm screws (AA)
One x Side Beam (R) (no holes)
One x Drip Tray Support (N)
One x Left Front Leg (J)
One x Left Back Leg (K)
Loosen Six pre-assembled M6*16mm screws (AA)
from "X" positions and leave the screw heads
protruding approximately 5mm.
Hang Side Beam (R) and Drip Tray Support (N) to
Left Front Leg (J) and Left Back Leg (K), then
tighten the screws at the "X" positions.
Take Two M6*16mm screws (AA) from the
hardware pack, and fasten the screws into the "Y"
positions.
Note: Be sure part (R) and (N) are installed
correctly as shown.
Page 8
J
H
N
X
Y
X
AA
Y
R
X
X
X
X
K
X
Y