General Safety Overview - UNI-T UTD1025CL Manual

General Safety Overview

The apparatus is strictly designed and produced
under the GB4793 Safety Requirements for
Electronic Measuring Apparatus and IEC61010-
1Safety Standard. The apparatus meets the over
Ⅲ 600
voltage standard CAT
standards for pollution level II
Please read the following safety prevention
measures to prevent personal injury and any
damage to the product or other products connected
with the product. To avoid any possible danger, the
product shall be applicable in the stitulated
scope and be repaired by the specially trained
personnel.
Warning: to prevent electric shocking or fire,
please use the dedicated adapter approved to
.
apply in the country
Warning: if the oscilloscope input port were
connected with the voltage higher than 42 V 30
2
V and safety
.
(
Vrms),to avoid electric shocking please
●
To use the voltage probe, test lead wire and
adapter with certain insulation attached with the
oscilloscope or use the accessories designated by
UNI-T applicable to oscilloscope apparatus
series product.
● Before using, check if any mechanic damage to
the multimeter test pen, oscilloscope probe and
accessories and please replace it if any damage
were found.
●
To remove all unused test pen, probe an
accessories.
● To insert adapter into the AC socket and connect
.
it with the oscilloscope
●
In measurement in the CAT
connect the voltage higher than 300V with the
oscilloscope input port and don t connect the
voltage higher than 600V with the multimeter input
Ⅲ .
port in the CAT ambient
UTD1000L User Manual
:
Ⅲ , '
ambient don t
'