Check Oscilloscope System Information; Automatic Parameter Measurement - UNI-T UTD1025CL Manual

UTD1000L User Manual

Check Oscilloscope System Information

To check oscilloscope system information under
the following steps:
1. Press key SHIFT to show character shift on
the right corner of screen
2. Press key CONFIGURE to open interface
;
configuration menu
3. Press key F4 the screen shall display
informations such as: type, versionof the present
oscilloscope.
4. Press key F1 to close system information
window.
;
Picture 4-16 System Information

Automatic Parameter Measurement

There are two ways of automatic parameter
measurement, showing all parameters or individually
set measured parameter to display on screen with
maximum of 4 parameter items
Measurement of All Parameters
To measure all parameters automatically under the
following steps:
.
25